Installation step: cleaning the brake caliper before fitting the cover

Step 1

Remove the Wheel and Clean the Caliper

Remove the wheel carefully so you have full access to the caliper. Clean the surface thoroughly, clearing away grease, brake dust, and dirt so the adhesive can bond properly.

Installation step: test-fitting the yellow caliper cover

Step 2

Dry-Fit the Caliper Cover

Before applying any adhesive, set the cover in place over the caliper to check the fit, alignment, and clearance from the wheel.

Installation step: caliper with clips prepared for the cover

Step 3

Apply High-Temperature Adhesive

Spread an even coat of automotive-grade adhesive across the mounting surface of the cover. Stick to heat-resistant adhesive made specifically for automotive use.

Installation step: placing the caliper cover over the caliper

Step 4

Mount the Cover on the Caliper

Place the cover onto the caliper and line it up exactly where you want it. Make sure it sits firmly and doesn't rub against any nearby parts.

Installation step: securing the caliper cover with tape while it sets

Step 5

Hold the Cover While the Adhesive Sets

If needed, use masking tape to keep the cover from shifting while the adhesive starts to cure, so the alignment stays exactly where you want it.

Finished installation: yellow caliper cover behind the alloy wheel

Step 6

Let the Adhesive Cure

Keep the vehicle parked for a minimum of 2 hours so the adhesive can set fully. For the strongest bond, follow the curing time recommended by the adhesive's manufacturer.